rotary tiller at tractor supply

1. When starting to work, the Rotary Cultivator Tiller should be in the raised state. First combine the power take-off shaft to increase the rotation speed of the cutter shaft to the rated speed, and then put down the Rotary Tiller to make the rotary tiller gradually sink. Blade to desired depth. It is strictly forbidden to combine the power output shaft or drop the rotary tiller sharply after the blade is buried in the soil, so as not to bend or break the blade and increase the load on the tractor.
2. During the operation, the speed should be as low as possible, which can not only ensure the quality of the operation, make the soil block thinner, but also reduce the wear of the machine parts. Pay attention to whether the rotary tiller has noise or metal knocking, and observe the broken soil and deep plowing. If there is any abnormality, stop the machine immediately for inspection, and continue working after troubleshooting.
3. It is forbidden to work when the ground is turning. The Farmland Rotary Tille should be raised so that the blades are off the ground and the tractor throttle should be reduced to avoid damage to the blades. When lifting the rotary tiller, the inclination angle of the universal joint should be less than 30 degrees. If it is too large, it will create impact noise and cause premature wear or damage.
4. When reversing, crossing the field, or turning the field, the Rotary Tiller should be raised to the highest position and the power supply should be cut off to avoid damage to the machine parts. If it is transferred to a distance, use the locking device to fix the rotary tiller.
5. After each shift, the rotary tiller should be maintained. Remove the dirt and weeds on the blades, check the tightness of each connection, add lubricating oil to each lubricating oil point, and add butter to the universal joint to prevent increased wear and tear.

QUICK COUPLER (3-point, set coupler)

The set action coupler which hitches at the three point on lower and top links is standard equipment.
It is simpler and more convenient than making the three point connections separrately or having the two point lower links only.
Even when the tractor and drive harrow are inclined in opposite directions, positive hitching is possible because coupler insertion is upward.

LEVELLING

Raking by the popular  drive harrow has been further improved and all improvements are embodied in the HR, HL series harrows.

HANDY WIRE CONTROLLER

The extending and retracthing of the extension rake, which removes traces of 'joints' between areas worked, is controlled from the tractor with this wire.
This wire remote control device is very useful when puddling at the border (levee) of a paddy field and when transporting.

SWING RUBBER (Special strong rubber)

Only possible by using rubber. Thanks to this rubber connection, a perfectly level finish is obtained with the levelling board even where the tractor sways from side to side on paddies or where there are plow furrows in dry fields. This 'swing rubber' connection is the result of cooperation in research and development between and a specialist maker of rubber products. The equipment ensures a good finish on stony fields and where raking is difficult.